4/30/2024 0 Comments Summit county utah parcel map![]() Ranch signs and similar entry structures for parcels greater than 5 acres.Sheds, provided that (1) the sheds are located in the rear or side yard and are located a minimum of 5 feet from all property lines (including the driplines of the shed) and (2) the maximum size of the shed does not exceed 200 square feet of floor area nor shall the maximum height exceed 8 feet. Sheds larger than 200 square feet must be located outside of the required setbacks.Walls and fences, as provided in Section 3505.17 of the Code.Flagpoles that do not exceed the maximum height limit established in the underlying zoning district.Driveways, including driveways that must be elevated due to topographic conditions.Uncovered decks and patios within 18 inches of finished grade.Bus shelters used as a part of a community transit system.Side: Any property line bounding a lot which is not designated as either a front or rear property line.Įxample of typical setbacks (for illustrative purposes only, exceptions may apply).Īccording to Section 3505.13.G of the Summit County Land Use and Development Code, the following minor structures and uses are allowed in any required setback, as long as they don’t obstruct motorists’ vision at access points.Each lot proposed for development shall have at least one property line designated as the rear lot line. However, where a lot is irregular in shape, the Planning Department shall determine which property line is to be designated as the rear property line for setback purposes. Rear: The property line opposite to and furthest away from the front property line is designated as the rear property line.See Figure 3-6 in Chapter 3 (pdf) of the Development Code for setbacks from the different road classifications. Regardless of which lot line is chosen as the front, all property lines adjacent to a roadway are subject to the applicable setback from that road classification. Each lot proposed for development must have at least one property line designated as the front lot line. If a lot is bordered by more than one street, the property owner must determine which side of the lot with street frontage is to be considered the front for setback purposes. Front: The property line separating a lot from the street.Lot lines are the legal boundaries of a parcel of land, established by a recorded subdivision plat and are classified as front, side, or rear: Call or visit the Summit County Planning Department to verify setbacks and any special plat restrictions for your property. Attached decks more than 18 inches above the ground, steps, cantilevers, eaves, roofs and other appurtenances must be included in the measurement of setbacks. Setbacks must be measured for the front, sides, and rear of the structure (applicable to a building) in relationship to the lot line. Setbacks are measured perpendicular from the closest point of the structure (building foundation walls, eaves, overhangs, decks, etc.) to the lot line or parcel boundary, as illustrated in the figure below. ![]() Refer to Section 3505.13: Setbacks in Chapter 3 (pdf) of the Development Code for a description, requirements and exceptions. General setback requirements from roads, property lines and buildings in specific zoning districts can be found in Figure 3-6: Minimum Setback Requirements (pdf) of the Development Code. Contact the Planning Department for details on RP zoning (97). Setbacks for RP (residential with plan) and PUD districts are stated in the RP plan or PUD designation. ![]() Setback requirements vary depending on zoning classification, road classification, and in some cases, a building envelope established through the platting of a subdivision. See below for detailed information on determining building height. You must know the setback requirements for your property prior to submitting a site plan to the County for a permit.īuilding height is the distance measured vertically from any point on a roof or eave to the natural or finished grade, whichever is more restrictive. A setback is the minimum required fixed distance from the property line to any structure on your property, including but not limited to roof appurtenances, chimneys, decks and bay windows.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |